Mortar, brick and crown work done code-correct the first time

Brick Chimney Repair in Galloway Built to Handle Jersey Weather

Brick Chimney Repair in Galloway means rebuilding the parts of your chimney that water and freeze-thaw cycles have chewed up: spalling brick, crumbling mortar joints, cracked crowns and failed flashing. We handle masonry chimney repair Galloway NJ homeowners call about after every hard winter, and we work on everything from 1920s Smithville farmhouses to newer builds off Jimmie Leeds Road. One call, one crew, no runaround.

↗
Fast online booking

Request service today

Tell us what is happening. Our local team will confirm your visit shortly.

No spam. No obligation. Just practical help.
Thanks — we'll call shortly to confirm your visit.
Chimney repair near me for Galloway homes
Careful work. Honest options.
About this service

What Brick Chimney Repair in Galloway Actually Involves

Brick Chimney Repair in Galloway is masonry restoration work that replaces damaged brick, repoints mortar joints, rebuilds crowns and reseals flashing so the chimney stops taking on water. We start with an inspection camera run down the flue and a hands-on look at the brick from the roofline up. Then we cut out the failed material with an angle grinder and masonry chisel, match the mortar color and hardness to the original, and rebuild in lifts so the joints cure properly. Most repairs run two to four hours; a full crown rebuild or upper-stack tear-out can take two days.

Galloway chimneys take a beating. Coastal humidity off Nacote Creek and the salt air near Leeds Point push moisture into porous brick, then a January freeze pops the face right off. We see mortar joint deterioration on almost every chimney over 30 years old, and damaged crowns on roughly half of them. If you have been searching brick chimney repair near me in Galloway and getting thin one-paragraph pages, that is because most outfits only sweep. We do the masonry. Call (844) 803-5147 and we will tell you straight what your stack needs.

  • ✓ Stop Water Intrusion
  • ✓ Protect the Flue Liner
  • ✓ Keep the Structure Sound
  • ✓ Pass Inspection and Sell
What's included

What Our Brick Chimney Repair Includes

Every job gets a written scope with photos before we start. Here is what is standard on a brick chimney repair, and what we price separately if your stack needs it.

✓

Full Roof-Level Inspection

We get on the roof, check the crown, cap, flashing and brick from every angle, and run an inspection camera down the flue. You get photos of every problem area and a written scope priced line by line.

✓

Brick and Mortar Replacement

Failed brick gets cut out with an angle grinder and masonry chisel. New brick goes in with mortar matched to the original color and hardness. We rebuild in lifts so the joints cure properly instead of cracking.

✓

Crown Rebuild or Repair

Cracked crowns get rebuilt with chimney crown mix and a proper overhang so water sheds off the edge. Small cracks can sometimes be sealed, but a crown that has separated from the flue gets rebuilt.

✓

Waterproofing Sealant

After the mortar cures, we apply a breathable waterproofing sealant like ChimneySaver. It keeps rain out while letting moisture vapor escape. This is what stops spalling brick from coming back in three or four winters.

✓

Cap, Damper and Flashing Check

We check the chimney cap, damper and flashing while we are on the roof. If the cap is damaged or the flashing has failed, we price the repair and can usually handle it the same visit.

✓

Written Scope and Photos

You get the written scope, before-and-after photos, and a workmanship warranty on the masonry. That documentation is what your insurance company or a home inspector wants to see.

How it works

How Our Brick Chimney Repair Process Works

01

Phone Triage

You call (844) 803-5147 and describe what you are seeing: brick flakes on the roof, a stain on the ceiling, a chimney that leans. We ask three or four questions, give you a ballpark range on the spot, and book a same-day or next-day visit. Emergency brick chimney repair Galloway New Jersey calls get moved to the front of the line.

02

On-Site Inspection

We get on the roof, run an inspection camera down the flue, and check the crown, flashing, damper and cap. You get a written scope with photos of every problem area, priced line by line. Takes about 45 minutes. No charge for the estimate.

03

Masonry Repair Day

We set up ladders and roof protection, then cut out the failed brick and mortar with an angle grinder and masonry chisel. New brick goes in with refractory mortar matched to the original color. Crowns get rebuilt with chimney crown mix and a proper overhang so water sheds off the edge instead of running down the stack.

04

Seal and Reassemble

Once the mortar cures, we apply waterproofing sealant, reinstall or replace the chimney cap, check the damper and flashing, and confirm the flue is clear. If we pulled a stainless steel liner or damper clamp, it goes back exactly where it was. Most jobs wrap in one day; crown rebuilds take two.

05

Walk-Through

We walk the roof with you or send photos if you would rather stay on the ground. You get the written scope, before-and-after shots, and a workmanship warranty on the masonry. If anything looks off in the first year, we come back. That is the whole deal.

Tools & methods

Tools and Methods We Use on Every Chimney

Purpose-built equipment, used by trained technicians — so the job is done accurately the first time.

Inspection Camera

We run it down the flue to check for cracked clay flue tile, creosote buildup and gaps at the smoke chamber. You see the footage, so you know exactly what we are pricing.

Angle Grinder and Masonry Chisel

Used to cut out failed mortar joints and spalled brick without cracking the surrounding masonry. Clean cuts are what make a repoint last instead of failing at the edges.

Tuckpointing Trowel and Mortar Hawk

The right tools for packing mortar into joints and tooling them so they shed water. We match mortar color and hardness to the original so the repair blends in.

Chimney Brush and Rods

For sweeping creosote and debris out of the flue before we inspect or repair. A clean flue is the only way to see cracks in the clay tile.

ChimneySaver Waterproofing Sealant

A breathable sealer applied after masonry repair. It keeps rain out while letting moisture vapor escape, which is what stops spalling brick from coming back.

Damper Clamp

Installed where code requires it, usually on gas appliance flues. It prevents the damper from closing fully so exhaust cannot back up into the house.

Real results

Before and after.

Spalling Brick on a Smithville Chimney

Before

A 1970s brick chimney in Smithville had spalling on the south and west faces, with brick flakes on the roof every spring. Mortar joints were eroded a quarter to half an inch. The crown had two hairline cracks.

After

We cut out 34 spalled brick, repointed 60 linear feet of joint, rebuilt the crown with chimney crown mix, and sealed the stack with ChimneySaver. The repair is invisible from the ground. Two winters later, no new flakes.

Chimney Leak in Galloway Township

Before

Water was staining the ceiling near the chimney in a Galloway Township home after every nor'easter. The flashing had pulled away from the roof on the north side, and the crown had separated from the flue by about an eighth of an inch.

After

We replaced the flashing and counter-flashing, rebuilt the crown with a proper overhang, and water-tested the repair. The ceiling stain stopped growing. Total job took two days, mostly cure time on the crown.

Full Upper-Stack Rebuild in Pomona

Before

A Pomona chimney had mortar joints eroded past three-quarters of an inch and a visible lean at the top. About 45 percent of the brick was spalled. A simple repoint would not have held.

After

We tore out the top eight courses, rebuilt with matched brick and mortar, poured a new crown, and installed a stainless steel cap. The chimney is straight and plumb again. Job took three days.

Problems we solve

Chimney Problems We Fix in Galloway

Most chimney damage traces back to water getting in somewhere it should not. Here are the four problems we see most often on Galloway stacks, and what happens if you leave them alone.

Ask a pro →
01

Spalling brick on the chimney face

We cut out the spalled brick, replace it with matched units, repoint the surrounding joints, and seal the stack with a breathable waterproofing sealant. Most single-face repairs take three to four hours.

↗
02

Mortar joint deterioration past half an inch

We grind out the failed mortar with an angle grinder, repack it with mortar matched to the original, and tool the joints so they shed water. Tuckpointing is the cheapest way to add decades to a brick chimney.

↗
03

Cracked or separated chimney crown

We rebuild the crown with chimney crown mix and a proper overhang so water sheds off the edge instead of running down the stack. Crown rebuilds take two days because the mix has to cure before we seal it.

↗
04

Failed flashing at the roof line

We replace the flashing and counter-flashing, seal it properly, and water-test the repair before we leave. If the leak has already damaged ceiling drywall, we will tell you what to watch for.

↗
Proof you can check

Licensed, Certified and Documented

✓
CSIA Certified Chimney SweepChimney Safety Institute of America
✓
NFI CertifiedNational Fireplace Institute
✓
NCSG MemberNational Chimney Sweep Guild
✓
New Jersey Home Improvement Contractor (HIC) LicenseNew Jersey Division of Consumer Affairs
✓
OSHA 10Occupational Safety and Health Administration
Good questions

Chimney Masonry Questions Galloway Homeowners Ask

(844) 803-5147 →

Most brick chimney repairs in Galloway run $350 to $1,800 in 2026, depending on how much brick and mortar has to come out. Simple tuckpointing on a single face is at the low end. A crown rebuild plus repointing plus waterproofing lands in the middle. Full upper-stack rebuilds start around $2,500. We give you a written scope with photos before any work starts.

We do. Thrive Sharp has been repairing brick and masonry chimneys in Galloway since 2021 and we handle the masonry work in-house, not through a subcontractor. Call (844) 803-5147 and we will book an inspection, usually same day or next day. You get a written scope, photos of the problem areas, and a price before we touch a brick.

Yes, in almost every case. Spalling brick, eroded mortar joints and cracked crowns are all repairable without tearing the chimney down. We cut out the failed material, replace it with matched brick and mortar, and seal the stack. The only time a rebuild makes more sense is when the chimney is leaning or more than about 40 percent of the brick is shot.

Water and freeze-thaw cycles cause most of it. Coastal humidity near Nacote Creek and Leeds Point soaks into porous brick, then a hard freeze pops the face off. Add mortar joint deterioration from age, a damaged crown that lets water in from the top, and salt air, and you get spalling brick within 25 to 30 years. Waterproofing after repair is what stops the cycle.

Ready when you are

Get Your Brick Chimney Repair in Galloway Scheduled

Call (844) 803-5147 and we will book an inspection, usually same day or next day. Written scope, photos, and a price before any work starts. Licensed, insured, and warrantied on the masonry.

Book an Inspection (844) 803-5147 →
Request an appointment

Get your chimney looked at

Call (844) 803-5147 or send us a message and we will get back to you the same business day. We book Monday through Friday, 8 a.m. to 6 p.m., with same-day and after-hours slots for active leaks and storm damage. Tell us what you are seeing and we will tell you what it takes to fix it.

Call anytime(844) 803-5147Email the office[email protected]
Office hoursOpen 24 hours · 7 days a week
Request received — our team will be in touch shortly.
Tap to call(844) 803-5147